11-6 Opening and closing the engine hood
● When you close the engine hood, be careful not to pinch your
Caution
hand.
● Do not open the engine hood at the windy place.
Disconnect the rubber catch in right and left,
and pull up the engine hood upwards until
the wire stretches to the limit. When you
close the engine hood, lower it slowly.
11-7 Opening and closing the seat undercover
When you close the undercover, be careful not to pinch your
Caution
hand.
Raise the tilt steering column to the upper
position first, and then move the seat to the
rear end position. Pull up the lever behind
the seat to release the lock, and then raise
the seat and open the undercover. To close
the undercover, lower it slowly.
Rubber catch
Seat
Lever
11-8 Adjustment of brake
Make sure that the brake wire is not cracked or damaged.
Caution
● If the brake is not sufficiently effective due to a wider clearance
Important
gap between the brake disc and the brake lining, adjust the
clearance.
● The wire is used for fine adjustments.
● Adjust the brake with the brake lining.
● Make sure that the lever is maintained in the open position
(neutral).
The brake lining wear limit is 3.0 mm (0.118 in).
1) F o r e a c h w h e e l , f u l l y t i g h t e n t h e
adjustment bolt on the brake disc side.
−28−
Brake lining
Brake disc
Open (neutral)
Adjustment bolt
(on brake disc side)
Lever