Abus Security-Center EcoLine TV7000 Installation Manual page 15

(8) Power status LED
This red LED is lit whenever the camera is
supplied with power. Only when the LED is lit can
a video signal be received from the VIDEO OUT
of the camera. A red lit LED does not indicate
that the camera is working without malfunction.
7. Installation
Please proceed as follows when installing the
camera:
1. Remove the CCD protection from the
camera by simply turning it counter-
clockwise.
2. Before mounting the lens on the camera,
ensure that the lens is a C- or CS-mount
type. If you wish to mount a C-mount lens,
the enclosed C-mount adapter ring (9) has
to be mounted first on the camera. To
change the setting of the C/CS-adjusting
ring, loosen the fixing screw (10) first,
change the setting and tighten it again
afterwards. (The majority of lenses on the
market are CS-mount lenses).
9
10
3. Mount the lens on the camera. Do not
forget to remove the lens cover from the
lens. Connect the auto-iris lens connector
to the connector (7) on the camera and
select the correct lens drive signal (6).
4. Connect the video cable (recommended
cable type: RG58) to the camera and the
following video unit. The max. cable length
should not exceed 200 m.
11
11
15