Groover Set-Up Model 3007 - Anvil GRUVLOK 1007 Manual

THE GRUVLOK MODEL 3007 ROLL GROOVER IS DESIGNED FOR USE
®
WITH A RIDGID
*
Removal of the Groover from the shipping box and mounting of the Groover to the Ridgid 300 drive should be accomplished by
2 persons. To avoid possible injury DO NOT ATTEMPT TO LIFT THE MODEL 3007 ROLL GROOVER BY ONE PERSON.
GROOVER SET UP MODEL 3007
RIDGID" is a registered trade mark of Emerson Electric Company.
*"
300 POWER DRIVE
Extend the mounting arms
1
of the Ridgid 300 power
drive, approximately 12" out
from the body of the drive.
The Ridgid 300 must be
mounted to the floor for
continuous operation.
Grasp the Groover base on
2
opposite sides, lift the Groover
out of the shipping crate and
place the mounting slots in the
groover base over the extended
mounting arms.
Align the flats on the triangular
3
shaft tailpiece with the Ridgid
300 chuck jaws and slide the
Groover back into the chuck
jaws. Securely tighten the
chuck jaws. Push extension
arms in flush with the Groover
mounting base front.
Install the larger diameter
4
of the support leg tube into
the receiving socket on the
under side of the groover base.
Push the tube fully into the
receiving socket assuring that
the angled cut on the tube
bottoms in the receiving
socket. Tighten the retaining
bolt on the groover base.
Repeat for the other leg
(9/ 16" wrench).
.
BUILDING CONNECTIONS THAT LAST
Extend the smaller diameter of
5
the support leg by loosening
the lock bolt on the support
leg and sliding the smaller
diameter tube to its required
length. Retighten the lock bolt.
( / " wrench). The support legs
9
16
must be mounted to the floor
for continuous operation.
Loosely attach pump assembly
to groover base using the 5/8"
6
nut and bolt provided, then
securely connect the coupler
located on the end of the hose
assembly to it's mating part on
the hydraulic ram.
The Groover should be leveled
7
for best grooving results. Place
level on top of hydraulic ram as
shown and adjust the support
legs as required to level the
Groover and provide a firm fixed
base location for both the
Groover and power drive.
Position the pump to the
8
desired orientation for ease
of operation. Tighten nut
to lock pump in position or
if desired, back off just
slightly to permit pump to
be oriented by operator to
most comfortable position
during groover operation
(15/16" wrench).
CAUTION
7