Groover Set-Up Model 1007 - Anvil GRUVLOK 1007 Manual

1007 & 3007 ROLL GROOVER
Removal of the Groover from the shipping box and mounting of the support legs should be accomplished only with the aid of a
hoist or other lifting device. To avoid possible injury DO NOT ATTEMPT TO LIFT THE MODEL 1007 ROLL GROOVER MANUALLY.
CAUTION
GROOVER SET UP MODEL 1007
1
Install a support leg tube into the receiving socket on the under side of the
groover base. Push the tube fully into the recieving socket assuring that the
angled cut on the tube bottoms in the receiving socket. Tighten the retaining
bolt on the receiving socket. Repeat for the other three legs (9/16" wrench).
2
The Groover should be leveled for best grooving results. Assure level position
of the Groover and provide a firm fixed base location for the Groover.
3
Position the pump to the desired orientation for ease of operation. Tighten nut
to lock pump in position or if desired, back off just slightly to permit pump to
be oriented by operator to most comfortable position during groover
operation (15/16" wrench).
6
4
With a flat screwdriver, open the door to the electrical storage cabinet.
Remove the power cord and foot switch from the cabinet mounted on the
Groover frame. Plug the power cord into a grounded electrical outlet that
matches the Groover. Power requirements: 110 volt, 30 amp or optional
230 volt.
5
Remove the padlocked lockout clip from the power switch. Turn the power
switch to the "on" position.
6
Turn the power switch to the "off" position when finished grooving or when
moving the groover. Install the lockout clip to the power switch and padlock
the lockout clip into position. (1/4" shank padlock).