Grooving Roll Change - Anvil GRUVLOK 1007 Manual

GROOVING ROLL CHANGE - ROLL REMOVAL
NOTE
With 2"- 6" grooving rolls installed – remove the bottom roll first, then remove the top roll. With 8"- 12" and 14" - 16" grooving rolls installed – remove
the top roll first, then remove the bottom roll.
A. GUIDE ROLL MOUNTING PLATE
If you have not removed the bottom roll (8"- 12" and 14"- 16" roll
removal) the weight of the top roll could pinch, or trap your hand
against the bottom roll.
4
Remove the top roll from between the front and back plates of the grooving
head. If the bottom roll has been removed, lower the roll out of the grooving
head. If the bottom roll has not been removed (8"-12" and 14"-16" roll
removal), raise the roll out of the grooving head.
"RIDGID" is a registered trade mark of Emerson Electric Company.
*
TOOLS REQUIRED
1
(1) Large Slotted Screwdriver
(1) 3/4" Wrench
(1) 3/₁₆" Allen Wrench
Using a large slotted
screwdriver and a ³/ "
4
wrench, loosen the hex
nut located on the top of
the adjustment shaft
protruding from the top
of the groover head.
2
Cradle one hand under the
3
top roll and pull the top roll
shaft out from the front.
CAUTION: The top roll is
heavy. Brace your hand to
receive the weight of this
component. As the shaft
disengages, the top roll
will fall into your hand.
BUILDING CONNECTIONS THAT LAST
B. TOP (GROOVED) ROLL
C. BOTTOM (DRIVE) ROLL
MODEL 3007 ONLY
2 Pull the bottom roll shaft out the front of the Groover.
Remove the quick release pin
1
by grasping the ring located on
the end of the pin and pulling
straight up.
Screw the 1/4" - 20 thumb
2
screw (same one that is used to
secure the depth gauges to the
main housing) into the tapped
hole in the top shaft.
Loosen and remove the socket
1
cap screw to remove the hinged
collar from around the bottom
roll shaft at the back of the
groover base ( 3/16" allen wrench).
Release the Ridgid 300 chuck
*
1
jaws from around the tailpiece
on the bottom roll.
13