Command Format; Entering The System Management Screen - AOR ARD9900 Operating Manual

Command Format

Run a terminal software program, and then turn the power of the ARD9900 on.
The following message should appear on the PC screen:
CMD>
This indicates the ARD9900 is ready to accept commands from the PC.
Each command consists of three (3) alphabetical characters.
CMD>CCC_NN [CR]
CCC: Command (Must be a capital letter)
_ : Space
NN: Parameter
[CR]: Carriage Return
Entering a command without a parameter will display the current parameter (value)
setting.
CMD>CCC[CR]
If an invalid parameter or command is entered, the ARD9900 will respond as follows:
CMD>
?
CMD>

Entering the System Management Screen

Using the AMA command with the master key code, you can enter the System
Management Screen.
[Note: The master key code consists of 12 digits of numeric code (0 ~ 9).
[Warning ! ]
The master key code MUST be kept in a secure place. Without the proper
master key code, no code changes can be made.
If you made an entry error entering a setting, correct it in the above entry screen.
If you exit from the master key code setting screen with a wrong code, neither
you nor our factory can change it.
Each command consists of three (3) alphabetical characters.
************
CMD>AMA_
( _ : space key)
CMD>
The factory default is 123456789012]
CMD>CCC_NN [CR]
CCC: Command (Must be a capital letter)
_ : Space
NN: Parameter
[CR]: Carriage Return
[CR] ( Enter the master key code.)
28
(Response from PC)