Table of Contents
Advertisement
Communication Mode Setting
The communication setting is set into discrete channels.
[Procedures]
Using the AMA command, enter the System Management Screen.
1.
Select the desired channel on the front panel.
2.
Using the ACP command, set the desired commnucation mode setting.
3.
To verify details of the setting, use the ACP command.
To verify details of the communication channel, use the ADS command.
[Example]
ACP [CR]
ADS [CR]
ACP [CR]
CH: 5 ID: 12345 NM: FFFFF MD: 0
CH: 5
ID: 12345
NM: FFFFF
MD: 0
23
Channel 5 is selected
Destination ID is set to 12345
Displays the nest mask setting. [ F] is indicating the
digit is valid.
Communication mode is [ 0 ] (Non encryption mode).
Advertisement
Table of Contents
