Table of Contents
Advertisement
Code Settting
Master Key code setting
A master key code is a password to allow the authorized operator access to System
Management for maintenance. For your security, our factory default setting code MUST
be changed with your own code prior to operation.
To change the Master Key code, type the [AMS] command using a PC.
[Note: The master key code consists of 12 digits of numeric code (0 ~ 9)]
[Refer to: Control commansd at page 27 for details.]
[Warning ! ]
The master key code MUST be kept in a secure place. Without a master key
code, no code changes can be made.
If you made an entry error during an initial setting, correct it under the above
entry screen. Once you exit from the master key code setting screen with a
wrong code, neither you nor our factory can change it!
User ID code Setting
The User ID code is a unique code for individual ARD9900 units.
To change the ID code, first type the [AMA] command to allow the user to go into the
Data management Menu.
[Note: The user ID code consists of 5 digits of numeric code (0 ~ 9)]
CMD>AMA_123456789012 [CR]
CMD>AMA OK
************
CMD>AMS_
************
CMD>AMA_
CMD>AMA OK
*****
CMD>AUI_
[CR]
Default: 77777
[Refer to: Control commands at page 27 for details.]
( Enter the factory default code.)
( _ : space key)
(Response from PC)
[CR]
(Enter a new master key code.)
[CR]
( Enter the master key code.)
(Response from PC)
(Enter a new user ID code.)
14
Advertisement
Table of Contents
