Jeep CHEROKEE 2021 Owner's Manual page 273

SSC has three states:
1. Off (feature is not enabled and will not
activate).
2. Enabled (feature is enabled and ready but
activation conditions are not met, or driver
is actively overriding with brake or throttle
application).
3. Active (feature is enabled and actively
controlling vehicle speed).
Enabling SSC
SSC is enabled by pushing the SSC switch, but
the following conditions must also be met to
enable SSC:
Driveline is in 4WD Low

Vehicle speed is below 5 mph (8 km/h)

The parking brake is released

The driver door is closed

Driver is not applying throttle

Activating SSC
Once SSC is enabled it will activate automatically
once the following conditions are met:
Driver releases throttle

Driver releases brake

Transmission is in any selection other than

PARK (P)
Vehicle speed is below 20 mph (32 km/h)

The set speed for SSC is selectable by the
driver, and can be adjusted by using the gear
shift +/-. Additionally, the SSC set speed may be
reduced when climbing a grade and the level of
set speed reduction depends on the magnitude
of grade. The following summarizes the SSC set
speeds:
SSC Target Set Speeds
1st = .6 mph (1 km/h)

2nd = 1.2 mph (2 km/h)

3rd = 1.8 mph (3 km/h)

4th = 2.5 mph (4 km/h)

5th = 3.1 mph (5 km/h)

6th = 3.7 mph (6 km/h)

7th = 4.3 mph (7 km/h)

8th = 5 mph (8 km/h)

9th = 5.6 mph (9 km/h) – If Equipped

REVERSE = .6 mph (1 km/h)

NEUTRAL = 1.2 mph (2 km/h)

PARK = SSC remains enabled but not active

NOTE:
During SSC the +/- shifter input is used for

SSC target speed selection but will not affect
the gear chosen by the transmission. While
actively controlling SSC the transmission will
shift appropriately for the driver-selected set
speed and corresponding driving conditions.
SSC performance is influenced by the Terrain

Select mode. This difference may be notable
to the driver and may be perceived as a
varying level of aggressiveness.
SAFETY 271
6