Storage, Unpacking And Handling - Recom RCM 6MB Series Installation And Safety Instructions

60/72 cell monocrystalline/polycrystalline/ silicon modules
Hide thumbs Also See for RCM 6MB Series:
Table of Contents

Advertisement

When installing the system, abide to all local, regional and national statutory regulations. Obtain a building
permit if necessary.
Under standard test conditions, the electrical characteristics are within ±5 percent of the indicated values of
Isc and Voc (irradiance of 100mW/cm², AM 1.5 spectrum, cell temperature 25°C (77°F)).
Only use equipment, connectors, wiring and support frames suitable for solar electric systems.

2. STORAGE, UNPACKING AND HANDLING

Packaged modules must be stored indoors; in a dry and ventilated area.
Once opened, continue to store modules in a dry and ventilated room.
Do not expose packaged modules to rain, snow, hail or other environmental conditions that will compromise
the modules or packaging.
To safely keep modules stored, they must remain packaged on the provided pallets, and must not be stacked
more than two pallets high.
Modules should never be stored in a wet or outdoor environment.
Upon unpacking, only carry a module by its frame with two or more people. Do not carry a module by the
wires or junction box.
Keep all electrical components clean and dry.
All modules are manufactured with a sealed junction box, pre-attached cables and locking connectors.
These components should not be modified or tampered with in any way.
Do not allow unauthorized persons near the installation site or module storage area.
Do not place or drop objects on top of the modules, including another module.
Do not place any load on the module.
Do not twist the module frame.
Do not stand, step, walk or jump on the module.
Do not handle modules with bare hands; avoid scratching, handling marks or any other damage, especially
to the front glass, back sheet or electrical components.
Do not mark the modules with sharp instruments.
Do not leave a module unsupported or unsecured.
Do not modify module frames in any way.
Installation Instructions UL-1703 and IEC / Rev. 05-2018 V.5
RECOM © Copyright 2018
UL AND IEC INSTALLATION GUIDE
p. 4 of 14
www.recom-solar.com

Advertisement

Table of Contents
loading

Table of Contents