Anomalies - Sources - Remedies; Disposal; Technical Data - Daewoo DAEQDP Series User Manual

7. ANOMALIES – SOURCES – REMEDIES
Anomalies
The pump won't start
The pump won't discharge
The pump won't stop
The flow rate is inadequate
The pump stops after working for a
short time

8. DISPOSAL

"Electrical products must not be thrown out with domestic waste. Recycle them at the
F special disposal centres provided for the purpose. Contact your local authorities or stocJ
L kist for advice on recycling".

9. TECHNICAL DATA

DAEQDP35-P
Power: 400 W
Max flow rate: 7000 L/min
Max delivery head: 7 m
Max pressure: 0,7 bar
Power cable length: 10 m
Max delivery temperature: 35 C°
Max immersion depth: 5 m
Max grain size: 5 mm
Sources
- Power not switched on
- The float switch is not connected to
the circuit
- The intake filter is clogged
- The discharge pipe is stuck
- The float switch is blocked in the
upper part
- The intake filter is clogged
- Pumping flow rate falls because the
pump is clogged with water
impurities
- The motor protection device stops
the pump because the water is too
dirty.
- The water is too hot, the heat
protector stops the pump.
DAEQDP70-P
Power: 750 W
Max flow rate: 13000 L/min
Max delivery head: 8 m
Max pressure: 0,8 bar
Power cable length: 10 m
Max delivery temperature : 35 C°
Max immersion depth: 7 m
Max grain size: 35 mm
4
Remedies
- Check the mains voltage
- Lift the float
- Clean the intake filter with a water jet
- Release the pipe
- Release the float and r eposition the
pump
- Clean the filter
- Clean the pump and its environment
- Pull out the plug and clean the pump
and sump
- Make sure the water temperature
does not exceed 35ºC!