Mitsubishi Electric Melservo HF-KN Series Instruction Manual page 51

5. WIRING OPTION
(c) When fabricating the encoder cable
When fabricating the cable, prepare the following parts, and fabricate it according to the wiring
diagram in (b). Refer to section 5.5 for the specifications of the cable to use.
Parts
(Connector set)
MR-J3SCNS
(one-touch connection
type)
(Note)
MR-J3SCNSA
(one-touch connection
type)
(Note)
Note. Cable clamp and bushing for 5.5 mm to 7.5 mm and 7.0 mm to 9.0 mm of cable outer diameter are included.
Servo amplifier-side connector
Receptacle: 36210-0100PL
Shell kit: 36310-3200-008
(3M)
or
Connector set: 54599-1019
(Molex)
5 - 16
Description
Encoder-side connector (DDK)
Straight plug: CMV1-SP10S-M2
Socket contact: CMV1-#22ASC-S1-100
Applicable wire size: AWG 20 or less
Angle plug: CMV1-AP10S-M2
Socket contact: CMV1-#22ASC-S1-100
Applicable wire size: AWG 20 or less