Troubleshooting - Klarstein Studio Light & Fire 1 Manual

Cleaning the electric electric fireplace
• Clean this appliance periodically by lightly running a vacuum cleaner nozzle over
the guards to remove any dust or dirt that may have accumulated inside or on the
unit.
• Do not use harsh detergents, chemical cleaners or solvents as they may damage the
surface finish of the plastic components.

TROUBLESHOOTING

Safety Cut-Out device
To ensure against the potential hazard caused by blockage of the air outlet, this
unit is equipped with an automatic overtemperature safety cut-out device. When the
device is activated the heater will not operate. If this occurs, the unit can be reset using
the following procedure:
1. Turn the fire off by depressing the on/off switch on the unit.
2. Unplug the power cord form the electrical mains supply socket and leave it
disconnected for at least 15 minutes.
3. Ensure that the air vents are free from obstruction.
4. Plug the power cord back in to the mains socket.
5. Turn the fire back on.
6. If the fire fails to operate, check the fuse in the plug.
7. If the fuse in the plug is OK and the fire is still not functioning, contact a qualified
service person.
Problem
No operation / no fan
No light
Solution
Check that the safety cut-off.hast not operated.
Check the fuse. If broken, a replacement is necessary.
Check the LED, if broken a replacement is necessary.
EN
23