Installation - Klarstein Studio Light & Fire 1 Manual

INSTALLATION

Warning: Danger of electric shock and other injuries
This product must be be installed as depicted in this instruction
manual.
Tools needed:
• 2mm pilot drill bit
• 8mm drill bit (the 8mm drill bit
• You may need to be a masonry bit
• Philips screw driver
• Power drill
Installation notes
Before continuing any further with the installation of this fire please read the following:
• Two people should be sufficient to lift the fire.
• When lifting always keep your back straight. Bend your legs and not your
• back.
• Avoid twisting at the waist. It is better to reposition your feet.
• Avoid upper body / top heavy bending.
• Always bend from the knees rather than the waist. Do not lean forward or sideways
whilst handling the fire.
• Always grip with the palm of your hand.
• Do not use the tips of fingers for support.
• Always keep the product as close to the body as possible to prevent unnecessary
and undue strain on the body.
• Use gloves to provide additional grip.
• Always use assistance if required.
Unpacking the product
The unit is supplied in a single package carton. Carefully unpack the product using the
following procedure:
• Ensure that the product is in the correct position with the carton wording legible.
• Remove the straps and sleeve.
• Carefully lift the fireplace out of the box.
• Remove the protective packaging and bag from the suite.
• Locate the fixing pack and put aside.
• Carefully remove the protective film covering the fire.
EN
19