Hardware Overview
Ports Panel
Interface
Console
Reset
WAN 1
LAN 1
WAN 2 /
LAN 2
Description
RJ45 serial console port for CLI management.
Use a RJ45-to-DB9 serial console cable to
connect the Console port to your computer.
Then configure using the following settings:
• Baud rate 115200
• Data bits 8
• Parity NONE
• Stop bits 1
• Flow control NONE
Resets to factory defaults. The UniFi Security
Gateway should be powered on. Press and hold
the Reset button for about 10 seconds until
the right LED on the WAN 2 / LAN 2 port starts
flashing and then becomes solidly lit. After a
few seconds, the LED will turn off, and the UniFi
Security Gateway will automatically reboot.
Supports 10/100/1000 Ethernet WAN
connections. Default setting is DHCP client.
Supports 10/100/1000 Ethernet LAN
connections. Default setting is DHCP Server.
Server IP: 192.168.1.1/24
Supports 10/100/1000 Ethernet connections.
Configure the port using the UniFi Security
Gateway configuration interface.