Table of Contents
Advertisement
SECTION 3: ASSEMBLING YOUR SNOW THROWER
After assembly, service engine with
IMPORTANT:
gasoline, and check oil level as instructed in the
separate engine manual packed with your unit.
NOTE: References to right or left side of the snow
thrower are determined from behind the unit in the
operating position.
Unpacking
• Remove staples or break glue on the top flaps
of the carton. Remove any loose parts included
with unit (i.e., operator's manual, etc.).
• Cut corner's and lay end of carton down flat.
Remove packing material.
• Roll unit out of carton. Check carton thoroughly
for loose parts before discarding.
D
A
Figure 1
Tools required for assembly
• Pair of Pliers
• Two adjustable wrenches
Loose parts in carton See Figure 1
A
(2) Handles (Right and Left)
B
(1) Handle Panel Assembly
C
(1) Speed Selector Plate
D
(1) Shift Lever
E
(1) Chute Directional Control Ass'y.
F
(1) Chute Assembly
(1) Hardware Pack
B
E
6
C
F
Hide quick links:
Advertisement
Table of Contents
