Table of Contents
Advertisement
Network Tests
11.3 Wired Network Tests
The wired network tests are used to verify connectivity to
resources on or off the network and IP addresses. The test
will simultaneously Ping up to seven different IP addresses
and can be run in DHCP or manual addressing modes.
To run tests, select Wired Network Tests from the Network
Tests menu and connect the ValidatorPRO-NT, Cu main
unit's Network jack to the interface to be tested.
In DHCP mode, the ValidatorPRO-NT, Cu's assigned
address and the addresses of the router/gateway and DNS
server plus the net mask are obtained automatically from a
DHCP server and the values displayed on the ValidatorPRO-
NT, Cu. Press select button on Get IP Parameters to start
the DHCP request process.
The Ping Tool soft key (F3) only shows on the IP address
screen once valid DHCP information or manual IP addresses
are configured.
Figure 11.4 Ping Tool – IP Address
For manual IP addresses, uncheck the DHCP mode box by
pressing the up and down arrow keys to highlight the DHCP
box and press Select to deselect DHCP mode. Use the
arrow keys to highlight the My IP, Gateway Router (GWRTR)
57
Advertisement
Table of Contents
