Table of Contents
Advertisement
Battery and Power Management
the ability to store usage information that can be used to
monitor the loss of capacity in the battery over time. Using
other batteries not supplied by JDSU will result in not
knowing the battery condition or state of charge.
Depending on the test being run, each unit can run on
battery power for up to eight hours. Since the remote uses
considerably less power than the ValidatorPRO-NT, Cu main
unit, a full day's use can be assured by swapping the
batteries between the two in the middle of the day.
The lithium-ion batteries for ValidatorPRO-NT, Cu can be
used and stored in locations that do not exceed 122 degrees
Fahrenheit (50 degrees Celsius) or 32 degrees Fahrenheit (0
degrees Celsius) limits. If the ValidatorPRO-NT, Cu senses
an out of range condition while charging, it displays Hot or
Cold below the battery symbol and suspends charging. The
remote flashes the charging light rapidly and suspends
charging for as long as the temperature is out of range.
ValidatorPRO-NT, Cu will not be able to provide accurate
test results if the AC power is not grounded properly. It is
recommended that both the main unit and remote are
operated on battery power (not AC power) during the
cable and PoE tests.
12
Advertisement
Table of Contents
