Table of Contents
Advertisement
Network Tests
If neither voltages nor Ethernet is detected, ValidatorPRO-
NT, Cu searches for its remote to run a cable test. If the
remote is found, a manual mode cable test is run and the
remote ID, wiremap, full Signal to Noise Ratio, and Skew
test results (1000Mbit only) are displayed. Speed testing, as
well as placing tone on a cable, is performed in the Manual
Test mode of the ValidatorPRO-NT, Cu only. If a remote is
not found, a one-ended test for shorts and split pairs is run
and the results are reported.
If the results appear to be un-powered Ethernet equipment,
that is reported as well.
To run Port Discovery tests, select Port Discovery from the
Network Tests menu and connect the ValidatorPRO-NT, Cu
main unit's Network jack to the interface to be tested.
56
Advertisement
Table of Contents
