Antenna Connections - Yamaha RX-V595 Owner's Manual

ANTENNA CONNECTIONS

Each antenna should be correctly connected to the designated terminals, referring to the following diagram.
Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal
strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may result in improvement.
Outdoor FM antenna
Connecting the AM loop antenna
1
1
2
3
* The AM loop antenna should be placed away from this unit. The antenna may be hung on a wall.
* The AM loop antenna always should be connected, even if an outdoor AM antenna is connected to this unit.
GND TERMINAL
For maximum safety and minimum interference, connect the
GND terminal to a good earth ground. A good earth ground is a
metal stake driven into moist earth.
01RX-V595-e/f2
75-ohm/300-ohm
antenna adapter
75-ohm coaxial cable
75-ohm/300-ohm
antenna adapter
300-ohm feeder
2
21
Indoor FM
antenna
(included)
(U.S.A. model)
75 UNBAL.
FM
ANT
GND
GND
AM
ANT
PHONO
Ground
3
Notes
• When connecting the indoor FM
antenna, insert its connector into the
FM ANT terminal firmly.
• If you need an outdoor FM antenna
to improve FM reception quality,
either 300-ohm feeder or coaxial
cable may be used. In locations
troubled by electrical interference, coaxial cable is preferable.
6/23/99, 4:09 PM
Outdoor AM antenna
AM loop
antenna
(included)
Orient so that the best
reception is obtained.
21