Impedance Selector Switch - Yamaha RX-V595 Owner's Manual

IMPEDANCE SELECTOR SWITCH

WARNING
Do not change the IMPEDANCE SELECTOR switch setting
while the power of this unit is on, otherwise this unit may be
damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE STANDBY/
ON SWITCH IS PRESSED, the IMPEDANCE SELECTOR
switch may not be fully set to either end. If so, set the switch
to either end fully.
IMPEDANCE SELECTOR
IMPEDANCE SELECTOR
SET BEFORE POWER ON
MAIN
A OR B: 4 MIN. /SPEAKER
A + B: 8 MIN. /SPEAKER
CENTER: 6 MIN. /SPEAKER
REAR : 6 MIN. /SPEAKER
MAIN
A OR B: 8 MIN. /SPEAKER
A + B:I6 MIN. /SPEAKER
CENTER: 8 MIN. /SPEAKER
REAR : 8 MIN. /SPEAKER
L
20
01RX-V595-e/f2
(U.S.A. model)
MAINS
AC OUTLETS
SWITCHED
100W MAX. TOTAL
20
Select the position whose requirements your speaker system
meets.
(Upper position)
Main: If you use one pair of main speakers, the impedance of
each speaker must be 4 or higher.
If you use two pairs of main speakers, the impedance
of each speaker must be 8 or higher.
Center: The impedance of the speaker must be 6 or higher.
Rear: The impedance of each speaker must be 6 or higher.
(Lower position)
Main: If you use one pair of main speakers, the impedance of
each speaker must be 8 or higher.
If you use two pairs of main speakers, the impedance
of each speaker must be 16 or higher.
Center: The impedance of the speaker must be 8 or higher.
Rear: The impedance of each speaker must be 8 or higher.
6/23/99, 4:09 PM