Yamaha RX-V595 Owner's Manual page 10

q
INPUT MODE
Switches the DVD/LD and TV/DBS input signal mode (AUTO/
ANALOG).
w
VOLUME
This control is used to raise or lower the volume level.
e
PHONES jack
When you use headphones, connect the headphones to the
PHONES jack. You can listen to the sound to be output from
the main speakers through headphones.
When using headphones only, set both SPEAKERS A and B to
the OFF position and switch off the digital sound field processor
(so that no DSP program name appears on the display) by
pressing EFFECT.
r
SPEAKERS
Set A or B (or both A and B) to the ON position for the main
speaker system (connected to this unit) you will use. Set it (or
them) for the main speaker system you will not use to the OFF
position.
t
A/B/C/D/E
Press this button to select a group (A to E) of preset stations.
y
Preset station number selector
Select a preset station number (1 to 8).
u
Tone controls
These controls are effective only for the sound from the main
speakers.
BASS
Used to increase or decrease the low frequency response. The
"0" position produces flat response.
TREBLE
Used to increase or decrease the high frequency response.
The "0" position produces flat response.
10
01RX-V595-e/f1
PHONES
10
i
BALANCE
This control is effective only for the sound from the main
speakers.
Adjusts the balance of the output volume to the left and right
speakers to compensate for sound imbalance caused by
speaker location or listening room conditions.
o
TIME/LEVEL
Press this button to select the setting of delay time or speaker
output levels in the TIME/LEVEL mode.
p
+/–
These buttons are used to adjust settings of the SET MENU
mode and the TIME/LEVEL mode. In the TIME LEVEL mode,
press + to increase delay time or speaker output levels. Press
– to decrease delay time or speaker output levels.
a
SET MENU
Press this button to select functions in the SET MENU mode.
s
PROGRAM selector
Press or to select the DSP program.
The name of the selected program appears on the display.
d
EFFECT
Switches on and off the output from the center and rear
speakers so that the sound becomes normal 2-channel.
* Even if the output from the center and rear speakers is off,
when the Dolby Digital is decoded, the signals at all channels
are distributed to the main channels and output from the main
speakers.
f
VIDEO AUX terminals
Connect an auxiliary video or audio input source unit such as a
camcorder to these terminals. The source connected to these
terminals can be selected by INPUT.
6/23/99, 4:09 PM