Oven Lighting; Indicator Lamp; Cleaning And Care - Siemens HQ74552.E Notes On Operation And Installation

Position the dripping pan on the first rack
height from the bottom (level B, fig. 3). This
level is exclusively for inserting the pan
when using the turnspit and/or grill. Before
closing the oven door, make sure rod "C"
fits correctly into hole "G" of the spit motor
shaft (fig. 4).
S
E
A
Level
Operating instructions
Fig. 2
F
D
Fig. 3
Fig. 4
C
G

Oven lighting

The oven lighting is switched on automati-
cally when you turn the control knob ( H ) to
any position to select a function.
Turn the temperature control knob to 0 °C if
you wish to switch on the oven lighting
without a heating element.

Indicator lamp

Indicates the oven's preheating phase; it
goes out when the oven reaches the tem-
perature set using the control knob.
The light will then alternate between off
and on. This indicates that the thermostat is
working correctly to keep the oven tem-per-
ature constant.

Cleaning and care

To ensure that you get the best from your
cooker for many years to come, you should
observe the following points when
cleaning it:
• Switch off the cooker at the mains before
starting to clean it.
• Avoid cleaning parts of the oven which
are still warm.
• Enamelled, chrome and glass compo-
nents must be cleaned with lukewarm
water only. Do not use abrasive powders
or corrosive cleaning agents which might
damage these parts.
• The oven should be cleaned with warm
water and washing-up liquid and then
rinsed and dried after every use.
• The steel parts, especially those areas
with symbols on them, must not be
cleaned using detergents or abrasive
cleaning agents. It is better to use a soft,
damp cloth and washing-up liquid (wip-
ing along the grain of the stainless steel).
Methylated spirits may be used to remove
stubborn dirt from stainless steel.
Once the cooker has been removed, the
parts should be rinsed thoroughly and
dried using a soft cloth.
35 35
GB