Zone 2; Zone 2 Connections - Yamaha RX-V3200 Owner's Manual

You can make up a multi-room audio-video system with this unit. This feature enables you to set this unit to reproduce
separate input sources in the main room and second room (Zone 2) with the supplied remote control in the second room.
Only analog signals are sent to the second room. For any source you want to listen to in the second room, you must
connect the analog output jack from the source to the corresponding analog input jack on this unit.

Zone 2 Connections

To use the multi-room functions of this unit, you need the following additional equipment:
• An infrared signal receiver in the second room
• An infrared emitter in the main room
This emitter transmits the infrared signals from the remote control in the second room to the main room
(for example, to a CD player or LD player)
• An amplifier and speakers for the second room
• A video monitor for the second room
OUT IN OUT
I Example of a system configuration and connections
Main room
DVD player
(or other component)
Notes
• When not using the main room, turn down the volume of this unit in the main room. Adjust the Zone 2 volume with the control on
the amplifier in the second room.
• DO NOT USE the Zone 2 feature for CDs encoded with DTS to avoid unexpected noise.

ZONE 2

REMOTE
IN CONTROL OUT
This unit
This unit
DVD INPUT
REMOTE CONTROL OUT
Infrared emitter
REMOTE CONTROL OUT
y
• Since there are so many ways to connect and use this unit in a
multi-room installation, we recommend that you consult with
the nearest authorized YAMAHA dealer or service center for
the Zone 2 connections which will best meet your
requirements.
• Some YAMAHA models are able to connect directly to the
REMOTE CONTROL OUT jack of this unit. If you own these
products, you may not need to use an infrared emitter. Up to 6
YAMAHA components can be connected as shown.
ZONE 2 VIDEO OUT
ZONE 2 AUDIO OUT
Amplifier Video
monitor
Remote control
Infrared signal
receiver
REMOTE CONTROL IN
Second room
69