Speaker Set (Speaker Mode Settings) - Yamaha RX-V3200 Owner's Manual

4
Press –/+ repeatedly to change the setting of
the item.
5
Press k / n repeatedly until the current DSP
program appears or simply press one of the
DSP program group buttons to exit from the
SET MENU.
or
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby
mode. However if the power cord is disconnected from
the AC outlet, or the power supply is cut for more than
one week, the stored data will be lost. If so, adjust the
items again.
10KEY DSP HALL 1 HALL 2 CHURCH JAZZ CLUB
1 2 3 4
ROCK ENTER- CONCERT TV
CONCERT TAINMENT VIDEO THEATER
5 6 7 8
MOVIE MOVIE /DTS
THEATER 1 THEATER 2 SUR. SELECT
9 10 11 12
+ +
0 10 100
1 SPEAKER SET (speaker mode
settings)
Use this feature to select suitable output modes for your
speaker configuration.
Notes
• When 96-kHz sampling digital signals are input to this unit,
level adjustments in items 1B,1E and 1F are possible, but those
in items 1A,1C and 1D are not affected.
• When 6CH INPUT is selected as the input source, level
adjustments in items 1A through 1E are not affected.
I 1A CENTER SP (center speaker
mode)
By adding a center speaker to your speaker configuration,
this unit can provide good dialog localization for many
listeners and superior synchronization of sound and
images. The OSD shows a large, small or no center
speaker depending on how you set this item.
Choices: LRG (large), SML (small), NONE
Initial setting: LRG
LRG
Select this if you have a large center speaker. The entire
range of the center channel signal is directed to the center
speaker.
SML
Select this if you have a small center speaker. The low-
frequency signals (90 Hz and below) of the center
channel are directed to the speakers selected with "1E
LFE/BASS OUT".
NONE
Select this if you do not have a center speaker. All of the
center channel signal are directed to the left and right
main speakers.
SET MENU
57