Jeep GRAND CHEROKEE 2021 Owner's Manual page 150

148 STARTING AND OPERATING
When enabled, active guidelines are overlaid on
the image to illustrate the width of the vehicle
and its projected backup path based on the
steering wheel position. A dashed center line
overlay indicates the center of the vehicle to
assist with parking or aligning to a hitch/
receiver. Different colored zones indicate the
distance to the rear of the vehicle. The following
table shows the approximate distances for each
zone:
Distance To The Rear
Zone
Of The Vehicle
Red
(0 - 30 cm)
1 ft - 6.5 ft
Yellow
(30 cm - 2 m)
6.5 ft or greater
Green
(2 m or greater)
Drivers must be careful when backing up
even when using the ParkView Rear Back Up
Camera. Always check carefully behind your
vehicle, and be sure to check for pedestrians,
animals, other vehicles, obstructions, or blind
spots before backing up. You are responsible
for the safety of your surroundings and must
continue to pay attention while backing up.
Failure to do so can result in serious injury or
death.
0 - 1 ft
To avoid vehicle damage, ParkView should

only be used as a parking aid. The ParkView
camera is unable to view every obstacle or
object in your drive path.
To avoid vehicle damage, the vehicle must

be driven slowly when using ParkView to be
able to stop in time when an obstacle is
seen. It is recommended that the driver
look frequently over his/her shoulder when
using ParkView.
WARNING!
CAUTION!
NOTE:
If snow, ice, mud, or any foreign substance
builds up on the camera lens, clean the lens,
rinse with water, and dry with a soft cloth. Do
not cover the lens.
Rear View Camera — Viewing At Speed
When the vehicle is in PARK,
NEUTRAL, or DRIVE the Rear View
Camera can be activated with the
"Backup Camera" button in the
Controls menu. This feature allows the
customer to monitor the area directly behind
the vehicle (or trailer, if equipped) for up to
10 seconds while driving. If the vehicle speed
remains below 8 mph (13 km/h), the Rear View
Camera image will be displayed continuously
until deactivated via the "X" button on the
touchscreen.