GREEN SERIES FITNESS 6000 Series Programming Manualline

Elevation error reprogramming

Hide thumbs Also See for 6000 Series:

Download this manual

6000 Series Treadmill

Elevation Error Reprogramming

Note: Go into the settings mode #3 and reset to factory settings. If it still have

the error code confirm the Elevation Settings in mode #6

Service Mode #3:

Erase The Custom Settings To Default Value

Pull out the safety key, press [Stop] for 5 seconds, message window show "ARE YOU SURE"

Press [Enter] to erase the custom settings to default value. Reconnect safety key.

Confirm Elevation works correctly. If EL error code continues go to Service Mode #6

Need help?

Do you have a question about the 6000 Series and is the answer not in the manual?

Page 1 6000 Series Treadmill Elevation Error Reprogramming Note: Go into the settings mode #3 and reset to factory settings. If it still have the error code confirm the Elevation Settings in mode #6 Service Mode #3: Erase The Custom Settings To Default Value Pull out the safety key, press [Stop] for 5 seconds, message window show “ARE YOU SURE”...
Page 2 [Enter] to next setting. Note: If this does not raise or lower the elevation go directly to Component Replacement guide or call Green Series Fitness Customer Support Max incline parameter: Message window Max incline display: Message window show “MAX AD OOO XXX”...
Page 3 Min incline parameter: Message window show To adjust Max incline parameter: Press ”MIN AD OOO XXX” ,OOO=old setting memory [Incline Up] or [Incline Down] to adjust the value, XXX=real time incline position parameter, incline motor position, the parameter will be press [Incline Up] or [Incline Down] to adjust change according to incline position, press the incline motor position, the parameter will...