Connection of the tap of clean water
Drill a hole 12 mm in diameter in the washer.
Assemble the tap in the following order:
1. Faucet
2. Cuvette
3. Rubber gasket
4. Plastic washer
5. Metal washer
6. engraving washer
Fix the faucet on the sink. In the nut (G) pull up blue (Fig.
1). The piston (H) insert the inside tube until it stops. Slip
into the end of the tube resistant plastic ring (F) (Fig. 2).
Screw on the threaded stem of the valve nut (Fig. 3).
1
G
H
The mineralizer connection
Install the case on brackets and connect it with tubes, while observing the flow direction: from
the case to the output, from the output to the tap of clean water (see pp. 5 and 7).
Check the reliability and correctness of all connections before the system
commissioning.
In order to prevent the carbon dust penetration to the membrane element and other
components of the system, it is recommended to wash carbon cartridges in case of the
first system commissioning, as well as at replacement of replaceable components of the
water preliminary purification.
Turn off the storage tank tap, open the tap of clean water and water feed tap. Water
will begin to drop from the tap of clean water in 3-5 minutes. Leave the tap of clean water
opened for 10 minutes, then close it and open the tank tap for several hours. A pressure
will be generated in the tank.
ATTENTION! Do not drink the water obtained during the first tank filling. Open the
tank with clean water after the tank filling, drain the WHOLE tank and refill it as described
above. This will take several hours depending on a pressure in the supply main. After this
the water can be drunk.
The system flush is required:
- after long (2 weeks) interruptions of usage;
- after maintenance (for example, replacement of cartridges)
After the filter commissioning the water color after purification can be muddy (turbid).
It is conditional upon air bubbles superseded from the filter. It is not a failure. Generally
these air bubbles disappear after the filter use.
2
F
SYSTEM FLUSH
1
2
3
4
5
3
6
11
Need help?
Do you have a question about the ALLEGRO and is the answer not in the manual?