Programming Instructions - Schartec Easy 800 N Installation And Operating Instructions Manual

Lock the emergency pull cord into the trolley until the carriage is locked
1
into the chain so that the garage door can no longer be moved by hand.
The operator can now be plugged in. The LED-display shows 99 down
2
to 11. Once finished, the operator is now in Standby-mode.
3
Finally, it displays "- -".
1
Press and hold SET until the operator displays "P1".
2
Press SET again, it displays "OP".
3
Then press and hold UP, it flashes "OP".
When the door has reached the desired open position, press SET, it
4
displays "CL".
Then press and hold DOWN, it flashes "CL". When the door has reached the
5
desired closed position, press SET.
The door opens and closes automatically to map the open and close
6
sensitivity force requirements.
7
It displays "- - " to show the process is complete.
NOTICE ON THE DRIVE END POSITION SETTING:
After the opening/closing positions have been successfully completed, please install this part in the rail.
PROGRAMMING
Preparing
Setting Open and Close Positions
Figure 20
35