Important Safety Instructions - Schartec Easy 800 N Installation And Operating Instructions Manual

Dear Customer
Thank you for choosing a quality product from the brand Easy "made by Schartec". Thanks to our unique
quality management system, we continuously ensure that Easy operators meet the highest standards of quality
and comfort. Thank you for your confidence in our products and we wish you much pleasure with your new
Easy garage door opener.

IMPORTANT SAFETY INSTRUCTIONS

1. Intended Use:
The garage door operator is designed exclusively for impulse operation of spring-balanced Sectional and Up & Over garage
doors in private / non-commercial operations. Door systems used in a public area have only one protective device, e.g. the
force limiter, and may only be operated under supervision. The garage door operator is designed for operation in dry rooms
only.
2. Unintended Use:
The garage door operator must not be used for purposes other than for the automation of garage doors. Continuous
operation and the use in the commercial sector is not permitted. The operator must not be used with doors without fall
protection.
3. Qualifications of the fitter and installer
Proper fitting and maintenance should only be done by a competent / specialist company or a competent / qualified person in
accordance with the instructions that can ensure the safe and flawless operation of the assembly. A competent person is, in
accordance with EN 12635, considered a person who has appropriate training, qualified knowledge, and practical experience
in order to mount a door system properly and safely.
4. Safety instructions for installation, repair, maintenance, and disassembly of the door system DANGER!
Compensation springs are under high tension.
The adjusting or loosening the compensating springs can cause serious injuries! If necessary, maintenance and repair work
must be made by a trained door system technician only! Never attempt to replace, readjust, repair, or move the balancing
spring for the counterbalancing of the door or their holders. Inspect that the entire door system (pivots, door bearings, ropes,
springs, and fastenings) for wear and possible damage. Check them for signs of rust, corrosion, and cracks. Error in the door
system or misaligned doors can cause severe injury! Do not use the door system if repair or adjustment work needs to be
done!
Mains Voltage
Danger! Risk of electrocution upon contact with the mains voltage. Therefore, please note the following instructions: Electrical
connections may only be performed by a qualified electrician. Electrical installation on site must comply with the relevant
safety regulations (230/240 V AC, 50/60 Hz).
Disconnect the operator from the mains before performing any operator service.
24