Installation Of Boom Rail And Operator - Schartec Easy 800 N Installation And Operating Instructions Manual

Mounting the Wall Bracket and Door Bracket
Figure 11

Installation of boom rail and operator

1. Place the adapter piece on the motor shaft. Attach the operator to the boom rail. Assemble the 2 "U" hanging
brackets with 6 mm nuts supplied.
2. Attach the Easy-Click bracket towards the back-half of the boom rail. Position it where you would like to
mount the boom to the ceiling. Once the bracket is in position, bend the 2 side pieces under to secure the
bracket to the boom.
Wall Bracket – Close the garage door and measure the garage
door width at the top and mark the center. Locate and mount the
wall bracket 2 cm - 15 cm above the door on the inside wall.
(Depending on the actual installation space).
Door Bracket – Attach the door bracket to a structural part of the
door as close to the top edge as possible.
Figure 12
Figure 13
33
Figure 14