Parameter Configuration - ElMod Fusion ECO Detailed Installation Instructions And User Manual

The factory settings of the
To change settings with the
• Power on the ElMod Fusion
• Start the ElMod App.
• After 2-10 sec. the ElMod Fusion
With the ElMod App various settings can be made and different informations are displayed. The main screen is divided in
four areas:
• On the upper edge there is a tab to choose the parameter's group.
• In the center area the parameters of the current category are listed. Each parameter has a detailed description. It is
shown whenever you hoover the mouse pointer over the parameter's name.
• Below are several buttons:
• "Load profile" loads a previously saved or provided setting profile from your hard disk.
• "Save profile" saves all current settings on your hard disk.
• "Help" shows a brief manual for the
• "About" shows the version number of the software and legal notes.
• "Quit" closes the ElMod
Very rarely will a profile fit a model perfectly. Different battery voltages, motor types, gear type and transmission ratio,
chain material and weight are just a few examples of characteristics that can have a drastic effect on the handling. To
create a new profile that fits your model, proceed as follows:
• Switch on the radio control, start your model and connect it to your computer and start the
• Load a profile that best matches your model. This profile is the basis for the following adjustments.
• Set the correct battery type (tab System. Parameters Battery type). Check if the current battery voltage shows a full
charged battery (tab System, parameter Battery Level ). If this is not the case, charge the battery first!
• Start the engine. Set the parameter Vmin (tab for this and all further parameters is Drive) so that the starting sound and
the motion of the vehicle occur in the same moment. Depending on the motor type and the chassis the value is between
1 and 20.
• If the model starts driving while the idle sound is still heard, raise the value.
• If the model doesn't move although the driving sound can be already heard, reduce the value.
• Set the parameters Vmax Ahead and Vmax Back to the desired value. The formula for converting the speed to the
original is: Speed of the model (in m/s) = speed of the original (in km/h) : (scale x 3.6). Example: the maximum speed of
the original vehicle is 60 km/h. The scale of the model is 1:16. The model should now drive 60 : (16 x 3.6) = 1.05 m/s.
• Set the shift points for the second and third gear so that they are evenly distributed (parameter: 2nd gear speed and 3rd
gear speed).
• If necessary adjust the acceleration values until you are satisfied with the result (value for Acceleration 3rd gear higher
as Acceleration 2nd gear, higher as Acceleration 1st gear).
• Adjust the speed of the spin turn (parameter spin turn speed) so that the vehicle is easy to control. If the original vehicle
was not able to perform a spin turn, set the value to zero to disable this feature.
• Now drive a few curves at top speed.
• If the radius of the curve is too large (vehicle does not steer strongly enough), increase the values for the parameters
Outer chain turn power and Inner chain turn power equally.

Parameter configuration

ElMod Fusion matches a german Panzer VI Tiger.
ElMod App a connection to the
and connect it to the computer.
will be detected and the current settings are shown on the screen.
ElMod App.
App.
Optimization of the driving characteristics
ElMod Fusion must be established. Proceed as follows:
- 13 -
ElMod app.
© ElMod - 19-12-28