Removing the camera
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in
Before working inside your
inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
1. Remove the
base
cover.
2. Remove the
wireless
card.
3. Remove the
solid-state
4. Remove the
rear-I/O
5. Remove the
computer
6. Remove the
memory
modules.
7. Remove the
display
assembly.
8. Remove the
display
bezel.
Procedure
1. Using a plastic scribe, pry the camera module from the display back-cover and antenna assembly.
2. Disconnect the camera cable from the camera module.
3. Lift the camera module from the display back-cover and antenna assembly.
computer. After working inside your computer, follow the instructions in
drive.
cover.
base.
After working
www.dell.com/
73