Removing The Display Panel; Prerequisites; Procedure - Dell Alienware 17 R4 Service Manual

Removing the display panel

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.

Prerequisites

1. Remove the base cover.
2. Remove the wireless card.
3. Remove the solid-state
4. Remove the memory modules.
5. Remove the rear-I/O
6. Remove the computer
7. Remove the display assembly.
8. Remove the display bezel.
9. Remove the logo board.

Procedure

1. Remove the four screws (M2x3) that secure the display panel to the display back-cover and antenna assembly.
2. Gently lift the display panel and turn it over.
3. Peel the tape that secures the display cable to the display panel.
4. Open the latch and disconnect the display cable from the display panel.
5. Lift the display panel off the display back-cover and antenna assembly.
70
computer. After working inside your computer, follow the instructions in
drive.
cover.
base.
After working
www.dell.com/