Philips SpeedPro Max Important Information Manual page 10

English
12
Problem
The LEDs in the nozzle do
not come on.
The appliance is not
charging.
FC6827, FC6826, FC6823,
FC6814, FC6813: The mini
turbo brush does not
function properly.
When I use my vacuum
cleaner I sometimes feel
static electricity shocks.
Possible cause
You have not installed the
roller brush in the nozzle
properly after cleaning.
You have not attached the
nozzle to the appliance or
handheld properly.
The magnetic connector is
not not connected correctly
to the charging disk or the
adapter is not inserted into
the wall socket properly.
You have not connected the
correct adapter and cord.
The roller brush is blocked.
The roller brush is blocked by
fabric or surfaces during
cleaning.
The mini turbo brush is not
fully closed.
Your vacuum cleaner builds
up static electricity. The lower
the air humidity, the more
static electricity the
appliance builds up.
You vacuumed up fine sand,
lime or a similar substance.
This also causes static
electricity.
Solution
Follow the instructions in the cleaning
chapter of the user manual to slide the
roller brush into the nozzle properly and
secure it inside the nozzle by snapping
home the locking lever.
Attach the nozzle to the appliance or
handheld properly.
Make sure that the magnetic connector
is connected properly to the charging
disk and that the adapter is inserted into
the wall socket properly.
Make sure that you use the correct
adapter and cord.
If you have checked the above and the
appliance still does not charge, take it to
a Philips service center or contact the
Consumer Care Center.
Remove hairs from the brush with a pair
of scissors (see user manual).
Keep the mini turbo brush aligned with
the surface and do not push the turbo
brush into soft surfaces.
Make sure that the top and bottom
parts of the mini turbo brush are
properly connected and there is no gap
between the two parts. Check if the
locking ring is in closed position (see
user manual).
Discharge the appliance by frequently
holding the tube against other metal
objects in the room (for example the
legs of a table or chair, etc.). You can
also raise the air humidity level in the
room.
Empty the dust container and clean the
filter according to the instructions in the
user manual.