Weber mt CR 5 Repair Instructions page 17

Figure 37
1
3
Figure 38
Figure 39
Service Information 2003
SERVICE - INFORMATION
Repair Instructions CR 5 - CR 6
Put the adjusting bushing (37/1) on the toothed
wheel (37/2).
1
2
Put the variable eccentric shaft (38/1) into the
adjusting bushing (38/2).
When fitting the variable eccentric shaft (38/
2
1)
(38/2), check to ensure that the feather key
groove (38/3) engages into the feather key
of the toothed wheel (36/1).
Put the variable eccentric shaft into the housing.
into the adjusting bushing
Section 6*** Page 17