Unloading The Smoker; Unpacking The Smoker; Site Instructions - Southern Pride SRG-400 Owner's Manual

Gas-fired wood-burning stationary rack bbq smoker

Hide thumbs Also See for SRG-400:

Owner's manual (38 pages)

Instruction manual (28 pages)

Table Of Contents

Table of Contents

Smokers Shipped via Common Carrier

Remove the crated smoker from the truck using the appropriate forklift. Note any damage to the crate, smoker

or accessories. Do not sign the delivery bill until the smoker has been inspected and any damage noted

on the delivery bill.

The smoker is shipped strapped to a wooden pallet with an industrial cardboard carton. Once the smoker is in

a level and safe place remove the cardboard carton. Located on top of the wooden pallet are two (2) wooden

ramps. Fasten the ramps to the edge of the wooden pallet using the metal clasps located on the end of the

pallet and ramps. The smoker is secured to the wooden pallet with metal banding straps. A board prevents the

smoker from moving. After removing the banding straps securing the smoker to the wooden pallet and the

board (with a Phillips screwdriver), release the brakes on each of the smokers casters. Then the smoker can be

slowly and carefully rolled down the ramps secured to the pallet.

Smokers Shipped via Contract Hauler

The driver will unload the smoker from the trailer. Once the smoker is in a level and safe place remove the

white protective wrap from the outside of the smoker.

The ash pan handle is secured to a product rack with a plastic zip tie.

•

The smoker is shipped with plastic zip ties holding the product racks to the rack slides. These zip ties

•

should be removed prior to initial operation.

The 6" (152mm) drain pan inside the smoker contains the restraining device.

•

The Southern Pride smoker must be installed in a location that will permit the smoker to function for its

intended purpose and to allow adequate clearance for ventilation, proper cleaning, and maintenance access.

Minimum Clearance Requirement from Combustible Material

Back......18" (457mm)

Top.......18" (457mm)

NOTE: If provision is made for service access, back clearance can be

WARNING: Failure to maintain proper safety, storage, handling, and ash removal for solid fuel

appliances on or around combustible materials may result in fire, property damage and/or death.

Our product listing allows for the smoker to be installed on a combustible surface however,

Southern Pride recommends the use of a noncombustible material for the floor surface area under

the firebox, which should extend at least 6" (152 mm) beyond each side of the firebox, and

outward from the smoker beyond the area needed for placement of the ash container.