Care should be taken to arrange the cord so that the cord cannot be pulled or tripped over. 13. Unit is only meant to be used with recommended Canister Fabric Steamer (model SF-562) 2 | ENGLISH...
Page 3
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. SAVE THESE INSTRUCTIONS Questions or comments? • steamfast.com • consumerservice@steamfast.com • 1-800-711-6617 Speak your mind! We invite you to review this product online: steamfast.com/reviews...
Product Information The following features and accessories are included with your unit. Carefully inspect the packing material for all parts listed below. To obtain possible missing parts, refer to Product Support on Page 13 of this manual for Consumer Service contact information. UNIT FEATURES &...
Page 5
• The Steam Nozzle (1) emits the flow of hot, penetrating steam produced by the Boiler. The Fabric Brush connects to the Steam Nozzle. • The Steam Nozzle Cradle (2) provides a safe and convenient place to hang the Steam Nozzle when not in use.
Page 6
Assembling Your Canister Fabric Steamer TELESCOPIC POLE SECTION 1 The Telescopic Pole is made up of three sections: (TOP) • TOP (SECTION 1) • MIDDLE (SECTION 2) • BOTTOM (SECTION 3) Sections 1 & 2 are adjustable in length. Section 3 is not adjustable. SECTION 2 By using the two extension locks, these sections may be extended (MIDDLE)
Page 7
CONNECTING HANGER Locate slot on the bottom of the Hanger. Insert Section 1 of the Telescopic Pole into the slot on the Hanger. CONNECTING STEAM HOSE Locate the bottom of the Hose, this is the side that does not have the Steam Nozzle on it. Screw the bottom of the Hose into the black holder on the top of the unit.
Using Your Canister Fabric Steamer FILLING WITH WATER 1. Remove Water Tank from main unit. 2. Holding Water Tank upside-down, unscrew and remove Valve Cap by rotating it in a counterclockwise direction. 3. Fill Water Tank with water through Valve Cap hole. At full capacity, the Water Tank holds 86 oz (2,543 ml) of water, and depending on the steam setting selected, will provide a continuous steam time of 96 minutes.
Page 9
3. Turn Steam Dial to desired steam level. 4. After approximately 45 seconds of heating time, unit will begin producing a flow of steam from Steam Nozzle. NOTE: It is common for the unit to produce gurgling sounds and small amounts of water during the first few minutes of steaming.
Page 10
• To remove particles like lint, hairs and threads, connect the Fabric Brush to the Steam Nozzle. • Certain fabrics are smoothed more easily from the inside. CAUTION: When using garment clips, grip clip handles securely and keep fingers away from grip pads to prevent pinching.
Storage & Care PROPER STORAGE Preparing your unit for storage is quick and simple. When you have finished your steaming tasks, follow the steps listed below. 1. Turn Steam Dial to Off position, and unplug power cord from electrical outlet. 2.
For problems with your unit, please refer to the troubleshooting guide located above. Additional inquiries should be directed to our consumer support services through our website, www.steamfast.com. If you do not have internet access, you may also contact our Consumer Service Department by telephone, at 1-800-711-6617.
When ordering replacement parts and accessories for your unit, you may refer to the part num- bers below. Parts and accessories may be ordered through our Website: www.steamfast.com You may also contact Consumer Service directly: consumerservice@steamfast.com or 1-800-711-6617 HANGER FABRIC BRUSH A562-002...
All such fees and costs shall be the sole responsibility of Buyer. Please allow at least 1-2 weeks for return of the Product after it is received by Steamfast. For ease of recordkeeping, it is recommended that Buyer staple or attached the original sales receipt to this Owner’s Guide and record the Product serial number (located on the Product specifications decal) here:...
Need help?
Do you have a question about the SF-562 and is the answer not in the manual?
Questions and answers