IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed including the following: 1. Read all instructions. 2. Do not touch hot surfaces. Use handles or knobs. 3. To protect against electrical hazards, do not immerse cord, plug or the appliance in water or other liquid.
GROUNDED PLUG To reduce the risk of electric shock this appliance has a grounded plug. (2 blades and 1 pin) If the plug does not fit fully into the electrical outlet contact a qualified electrician. Do not modify the plug in any way or use an adaptor. DESCRIPTION OF PARTS 1.
Page 4
7. Water Level Indicator Can be seen visually in the Water Container. Do not operate the Steamer without water in the Water Container. 8. Steamer Base Houses the Reservoir and Water Container. It also supports the Hanger Rod and Hose. 9.
Page 5
ASSEMBLY Hanger Rod Place the appliance on a steady surface. The bottom rod is threaded on one end. Screw the two larger rods together. Insert the bottom of the rod into the holder Ill. 5 on the unit base and screw the set screw until tight. NOTE: Do not over tighten.
Page 6
Replace the valve and return the Container to the upright position. Place the Water Container onto the base and make certain it is seated properly in the cavity. (Ill. 8) 3. Plug the Power Cord into a 120 Volt A.C. outlet. Turn the On/Off Switch to the ‘On’...
HELPFUL HINTS 1. Pressing will be easier if there are fewer creases in the object to be steamed. 2. Shaking out the article prior to steaming will avoid excess creasing. 3. Towels, handkerchiefs and napkins should be draped over a rod or steam pressed in place over a towel rack.
TROUBLESHOOTING GUIDE SOLUTION PROBLEM CAUSE Steamer fails Steamer not plugged in or auto Plug into electric outlet. • to heat shut-off engaged Check Water Container • is not empty. Reset On/Off Switch. • No steam Water level is low. Turn On/Off Switch ‘Off’ and refill Water Container.
LIMITED WARRANTY SALTON warrants that this appliance shall be free from defects in material and workmanship for a period of one year from the date of purchase. During that period these defects will be repaired or the product will be replaced at SALTON's option without charge.
Need help?
Do you have a question about the Salton SF-450 and is the answer not in the manual?
Questions and answers