Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Advertisement
Table of Contents
Related Manuals for Steamfast SF-450
Summary of Contents for Steamfast SF-450
- Page 1 Steam Fast Built for years of care-free use, Read These Ins tructions complete before use. MODEL SF-450...
- Page 2 302° F causing the steamer to shut off. web site: www.topinnovations.com Model SF Professional Style Steamer Top Innovations, Inc. 400 NW Platte Valley Dr., Riverside, MO 64150...
- Page 3 INTRODUCTION Congratulations! You are about to use the simplest and most Versatile steamer brought to you, SteamFast, a trusted name in clothing care. Your new steamer provides clean, professional results every time! 1. Holds over approximately 30 minutes of continuous operation. 2.
-
Page 4: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, always follow basic safety precautions, including the following: 1. Read all instructions. 2. To protect against risk of electrical shock, do not put appliance in water or other liquid. 3. Close supervision is necessary when any appliance is used by or near children. - Page 5 LEARNING ABOUT YOUR STEAMER Please refer to the picture for each point (1) The control HANDLE on the end of the hose sits just before the nozzle. The HANDLE is designed to be heat free and is safe to grasp. Use the HANDLE to aim the direction of the steam released from the nozzle (2) The NOZZLE on the end of the handle is located...
-
Page 6: Steamer Assembly
STEAMER ASSEMBLY STEP 1 ATTACHING THE METAL ROD Set the appliance on a steady surface. The bottom metal rod is threaded on one end. Screw the two larger metal rods together. Insert the bottom of the metal rod into the holder on the unit base and screw the setscrew until tight. -
Page 7: Steamer Operation
STEAMER OPERATION STEP I PREPARATION FOR USE Set the unit on the floor and remove the water container. Check the inside of the container for sediment. Turn the container upside down and push the valve open and allow to close two or three times to insure it is functioning smoothly. - Page 8 PRESSING WITH STEAM 1. Grasp the control handle with the nozzle facing upward. Beginning at the bottom of the fabric will allow the steam to rise inside and outside removing wrinkles. Slowly move the nozzle from the bottom to the top of the fabric. 2.
- Page 9 Accessories Fabric Brush Your steamer is supplied with accessory fabric brush which can be used to gently brush the knap of fabric such as corduroy. To install simply snap into the appropriate slot in the nozzle when the steamer is off and cool. Don't use the brush on delicate fabrics such as silk or satin Lint Remover...
-
Page 10: Cleaning And Storing
CLEANING AND STORING a. Turn the ON/OFF switch to the OFF position and unplug from the power source. b. Wait for the steamer to cool completely for at least 30 minutes. c. Remove and drain the water container. Drain the unit by removing the drain plug and allowing the contents of the, reservoir to drain. - Page 11 TROUBLESHOOTING THE STEAMER PROBLEM Steamer fails to heat No steam from Water drips nozzle Condensation in hose Nozzle gurgles Steam is intermittent Note: Water chemicals and conditions will vary in different areas. To insure continued operation of the steamer, never store without cleaning and removing excess water from the reservoir and water container.
-
Page 12: Removing Mineral Buildup
Removing Mineral Buildup One common problem with steamers is mineral buildup caused by the high mineral content in many municipal water supplies. Mineral residue inside of the internal pipes and heater can cause intermittent steaming or in severe cases no steaming at all.
Need help?
Do you have a question about the SF-450 and is the answer not in the manual?
Questions and answers