Maintenance - Cembre B35M-TFC Operation And Maintenance Manual

ENGLISH
– Fully insert the locking pin (17) into the head.
The die set is polarised and can only be installed one way to ensure the correct insertion of
the locking pin (17).
– To remove the die set from the head: open the locking lever (18), completely remove the locking
pin (17) and slide the die set out of the tool.
2.7) Battery status
The battery is equipped with LED indicators that indicate the remaining battery life at any time by
pressing the adjacent button (P).
4 LEDs illuminated: Fully charged
2 LEDs illuminated: 50 % capacity
1 LED fl ashing: Minimum charge, replace the battery
W W
HEN THE BATTERY VOLTAGE HAS DROPPED BELOW A MINI HEN THE BATTERY VOLTAGE HAS DROPPED BELOW A MINI
MUM SAFETY THRESHOLD MUM SAFETY THRESHOLD
IS NECESSARY TO RECHARGE OR REPLACE THE BATTERY IS NECESSARY TO RECHARGE OR REPLACE THE BATTERY
The approximate time to fully recharge a battery is about 40 minutes.
2.8) Insertion/replacement of battery
To replace the battery, remove it by pressing the release button (15) (Ref. to Fig. 6 page 26), then
insert the new battery, sliding it into the guides until it locks.
3. WARNING
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO COOL DOWN
FOLLOWING UNINTERRUPTED
A FULLY CHARGED BATTERY IN ONE SESSION
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER SUPPLY
D
O NOT USE THIS TOOL ON LIVE CABLES
P
ROTECT THE TOOL FROM RAIN AND MOISTURE
E -
LECTRO HYDRAULIC TOOLS SHOULD NOT BE OPERATED IN POURING RAIN OR UNDER WATER
3.1) Using the battery charger
Carefully follow the instructions in the battery charger manual.

4. MAINTENANCE

The tool is robust, completely sealed, and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance of the tool:
, ,
THE TOOL WILL NOT START THE TOOL WILL NOT START
,
SUCCESSIVE CUTTING OPERATIONS
,
DELAY BATTERY REPLACEMENT FOR A FEW MINUTES
.
- -
, ,
AND IT AND IT
. .
;
FOR INSTANCE
. W
ATER WILL DAMAGE THE TOOL AND BATTERY
2
P
,
HAVING EXHAUSTED
.
.
.
.
6