Detune; Assignment Parameters; Part Mode - Yamaha MU128 Owner's Manual

Multi Edit Mode

Detune

Detune
Range: –12.8 — +12.7
This determines the fine tuning of the
Part's Voice.
HINT
Detune could be used to slightly detune a
Voice compared to the tuning of the rest of
the Voices for a richer sound. It could also be
used to detune two different Voices being
played in unison. For example if two differ-
ent Parts are set to the same MIDI channel
(see Receive Channel above) and same Voice,
a naturally thick chorusing effect can be ob-
tained by slightly detuning each Voice in op-
posite directions here.

Assignment Parameters

Part Mode

Settings: normal, drum, drumS1 — S4
Height of bars indicates selected Part Mode
setting for each Part. (A single bar indicates
"normal" setting.)
This determines the mode for the Part. A
setting of normal allows selection of the
normal instrument Voices. (See the
SOUND LIST & MIDI DATA booklet.)
The drum setting allows selection of the
drum kits. (See the SOUND LIST &
MIDI DATA booklet.) The drumS1 —
S4 settings are locations for storing spe-
cially programmed drum setups. These
setups can be edited by using the Drum
Setup controls in the Multi Edit mode.
120
(See page ??.) The drum and drumS1
— S4 settings are not available in the Per-
formance mode (all Parts are fixed to
"normal").
The Part Mode settings differ depending
on the Sound Module mode selected, as
described below.
For XG mode:
All settings described above are available.
When normal is selected, any of the ba-
sic or the extended set of Voices can be
used for the Part.
For TG300B mode:
The settings normal and drumS1 — S4
are available; drum cannot be selected.
When normal is selected, either the ba-
sic or the extended set of Voices (for the
TG300B mode) can be used for the Part.
For PFM (Performance) mode:
All four Parts are set to normal; none of
the drum settings are available. Any of
the basic or the extended set of Voices
can be used for each Part.
NOTES
• The following are the default factory set-
tings:
XG mode
Part 10 (A10): drumS1
Part 26 (B10): drumS3
Part 42 (C10): drum
Part 58 (D10): drum
Other parts: normal
TG300B mode
Part 10 (A10), Part 26 (B10), Part 42
(C10), Part 58 (D10): drumS1
Other parts: normal
• When two or more different Parts are set to
the same editable drum setup (drumS1 —
S4), any edits made to that drum setup au-
tomatically affect all those Parts. For ex-
ample, when two Parts are set to drumS1,
any changes made to drumS1 affect both
Parts.
MU128 Multi Mode