Husqvarna R 419TsX AWD Operator's Manual page 25

Tire pressure
Make sure to have the correct tire pressure on all 4 tires.
Technical data on page 37 .
Refer to
To put the cutting deck in the servicing
position
1. Do the steps 1–7 in
page 14 .
2. Pull and hold the lock handle.
3. Hold the front edge of the cutting deck and pull
forward while you hold the lock handle. Pull the
cutting deck to the end position.
Note: If you can not pull the cutting deck to its end
position, release the lock handle and pull it up again.
880 - 006 - 09.09.2020
To attach the cutting deck on
4. Lift the cutting deck to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.
5. Carefully pull the front edge of the cutting deck
forward, to make sure that the cutting deck is locked.
To put the cutting deck in mow position
1. Hold the front edge of the cutting deck (A) with one
hand. Push the cutting deck in the direction of the
product.
2. Pull the lock handle (B) with your other hand to
disengage the locked position of the cutting deck.
B
3. Fold down the cutting deck (C) until it is level to the
ground.
4. Pull the lock handle and push the cutting deck in the
direction of the product until it stops.
5. Push down the lock handle.
To do a check of the parallelism of the
cutting deck
1. Make sure that the air pressure in the tires is correct.
Technical data on page 37 .
Refer to
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the servicing position.
A
C
25