Husqvarna R 419TsX AWD Operator's Manual page 18

6. Let the engine run at half throttle for 3-5 minutes
before you apply heavy load.
7. Push the throttle control to the full throttle position.
To operate the product
1. Start the engine. Refer to
page 17 .
2. Release the parking brake.
3. Carefully push down one of the speed pedals. The
speed increases the more the pedal is pushed down.
Use pedal (A) to move forward, and pedal (B) to
move rearward.
4. Release the pedal to brake.
5. Select cutting height (1–7) with the cutting height
lever.
6. Move the lift lever forward to lower the cutting deck
to mow position.
18
To start the engine on
A
B
7. Pull the PTO button to engage the drive on the
blades.
To stop the engine
1. Push the PTO button to disengage the drive on the
cutting deck blades.
2. Pull the lift lever for the cutting deck rearward to lift
up the cutting deck.
3. Apply the parking brake.
4. Turn the ignition key to the stop position.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
Maintenance schedule for the
schedule. Refer to
operator on page 19 .
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, see
37 ). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
cutting result also at a higher speed.
• Cut the grass in an irregular pattern.
• To get the best cutting result, cut the grass
frequently and use the BioClip function.
Technical data on page
880 - 006 - 09.09.2020