Husqvarna R 419TsX AWD Operator's Manual page 22

6. Install in opposite sequence.
To remove and install the left footrest plate
1. Remove the frame tunnel cover. Refer to
and install the front cover of the cutting deck on page
21 .
2. Remove the 3 screws and remove the footrest plate.
3. Install in opposite sequence.
To remove and install the outer right side
cover
1. Open the engine cover. Refer to
install the engine cover on page 21 .
2. Remove the 6 screws and remove the right side
cover.
3. Install in opposite sequence.
To remove the lower belt covers
1. Remove the screws that hold the lower belt cover.
There are 2 screws on the right side of the product
and the 3 screws on the left side.
2. Remove the lower belt cover.
3. Assemble in opposite sequence.
22
To remove
To remove and
To examine the steering wires
The tension of the steering wires can decrease after a
period of time. This causes the adjustment of the
steering to change.
Examine and adjust the steering as follows:
1. The steering wires are correctly tightened if you can
manually move them 5 mm up or down in the groove
on the steering collar.
2. If the wires are too loose, let an authorized service
agent adjust them.
To do a check of the parking brake
1. Park the product on a slope with a hard surface.
Note: Do not park the product on a grass slope when
you do a check of the parking brake.
2. Push the parking brake pedal down (A).
3. Push and hold the lock button (B) and release the
parking brake pedal while the button is pushed.
A
4. If the product starts to move, let an approved service
agent adjust the parking brake.
5. Push the parking brake pedal again to release the
parking brake.
To replace the fuel filter
1. Open the engine cover.
2. Move the hose clips away from the fuel filter with a
pair of flat pliers.
B
880 - 006 - 09.09.2020