Advertisement
Quick Links
Tool in open position
Positioner
Guide
Selector Index
Positioner
Z80-292
These Hand Crimp Tools have been designed for use with the following Datamate Mix-Tek coax Crimp
M80-305 to 307.........................................Straight female coax crimp contact
M80-308 & 309... (Z80-293 only)..............90° female coax crimp contact
M80-315 to 317............................. .............Straight male coax crimp contact
M80-318 & 319... (Z80-293 only)...............90° male coax crimp contact
Harwin North America
T: +1 603 893 5376 F: +1 603 893 5396
E: mis@harwin.com W: www.harwin.com
IS-34
Issue: 3 Date: 19.03.2013
HAND CRIMP TOOLS Z80-292 & Z80-293
Safety Clip
[when used with positioner Z80-291]:
T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590
E: mis@harwin.co.uk W: www.harwin.com
C/Note: 11973
Die Set
(Used in Mix-Tek female crimp connectors)
(Used in Mix-Tek female crimp connectors)
(Used in Mix-Tek male crimp connectors)
(Used in Mix-Tek male crimp connectors)
Harwin Europe
Tool in closed position
Z80-293
Harwin Asia
T: +65 6 779 4909 F: +65 6 779 3868
E: mis@harwinasia.com W: www.harwinasia.com
Page 1 of 5
Advertisement
Related Manuals for Harwin Z80-292
Summary of Contents for Harwin Z80-292
- Page 1 HAND CRIMP TOOLS Z80-292 & Z80-293 Tool in closed position Tool in open position Die Set Positioner Guide Selector Index Safety Clip Positioner Z80-292 Z80-293 These Hand Crimp Tools have been designed for use with the following Datamate Mix-Tek coax Crimp [when used with positioner Z80-291]: M80-305 to 307…………………………………..Straight female coax crimp contact...
-
Page 2: Table Of Contents
CONTENTS Contents ..............................2 General information ..........................3 Tool preparation ............................3 Wire stripping details ..........................4 Crimping procedure Z80-292........................4 Crimping procedure Z80-293 ........................5 Care of tool .............................. 5 IS-34 Issue: 3 Date: 19.03.2013 C/Note: 11973 Page 2 of 5... -
Page 3: General Information
GENERAL INFORMATION The Hand crimp tools Z80-292 & Z80-293 consist of a basic hand tool, which should be used with a positioner or die set. The contact is correctly crimped when the tool is free to open at the fully closed position, i.e., when the ratchet releases. -
Page 4: Wire Stripping Details
Straight coax connector Fig A 90° coax connector Fig B CRIMPING PROCEDURE Z80-292 1. Ensure that the wire to be crimped is within the specified range of sizes for the contact and the crimp tool. Failure to use the specified wire size will result in poor quality crimps and possible tool damage. -
Page 5: Crimping Procedure Z80-293
0.128” (3.25mm) A/F CARE OF TOOL There is virtually no maintenance required for the Z80-292 & Z80-293. However, it is good practice to keep the indenter tips free of residual colour band deposits and other debris. A small wire brush may be used for this purpose.