Yamaha SU200 Owner's Manual page 45

B
Press [-1/NO] or [+1/YES] or turn knob 1 to select the item to be loaded
If Volume Load: Select the volume to be loaded, by volume/file number.
If Wave Impt: Select the name of the WAV file to be loaded.
If Sample Load: Select the volume (by volume/file number), then press the [LOAD] button (pad 6), and then
select the sample within the volume (by bank and pad number).
N
Press the [LOAD] button (pad 6). The SU200 prompts you to select the pad that you
want to load the sample into (bank letter/pad number).
If Wav Impt:
SAVE LOAD
C A R D
If Sample Load:
SAVE LOAD
C A R D
M
Press [-1/NO] or [+1/YES] or turn knob 1 to select the destination pad (by bank letter
and pad number).
<
Press the [LOAD] button (pad 6) to execute the load.
SAVE LOAD
C A R D
CAUTION
• Do not remove the memory card or switch off the power while loading is in progress.
• If you are using the Wave Import feature, note that the wave file must be 16-bit linear with a sam-
NOTE
pling frequency of 44.1, 22.05, 11.025, or 5.5125 kHz. Although the SU200 may successfully load
files that were recorded at other frequencies, it will not play them back correctly.
+ or
–1/NO 1/YES
BPM
D E L E T E
D E L E T E
D E L E T E
Go to Step 8.
Go to Step 6.
Go to Step 6.
DATA REC TRGLVL
EFFECT
1 2
CONTROL
To?
Load
Load destination (bank letter / pad number)
To?
Load
A-4 A-1
Load source
(bank letter / pad
number)
The SU200 loads the data and then exits from Job
mode.
Chapter 6 Using Memory Cards
A-1
Load destination
(bank letter / pad
number)
45