Yamaha S03 Owner's Manual page 78

16-1. Flt BP1
(Filter Scale Break Point 1)
16-2. Flt BP2
(Filter Scale Break Point 2)
16-3. Flt BP3
(Filter Scale Break Point 3)
16-4. Flt BP4
(Filter Scale Break Point 4)
Set the Break Points for each Element. BP1 to BP4 will
be automatically be arranged in ascending order across
the keyboard.
PAGE PART ELEM KEY
16 E 1
OCTAVE
PAGE PART ELEM KEY
16 E 1
OCTAVE
❏
Settings: Flt BP1~Flt BP4: C-2 ~ G8
17-1. Flt Ofs1
(Filter Scale Offset 1)
17-2. Flt Ofs2
(Filter Scale Offset 2)
17-3. Flt Ofs3
(Filter Scale Offset 3)
17-4. Flt Ofs4
(Filter Scale Offset 4)
Set the Filter Scaling Offset Levels. These Offsets are
used by the Break Points (BP1/BP2/BP3/BP4).
n Details about Filter Scaling are given later in the section
"Filter Scaling Settings"on page 78.
PAGE PART ELEM KEY
17 E 1
OCTAVE
PAGE PART ELEM KEY
17 E 1
OCTAVE
❏
Settings: Flt Ofs1~Flt Ofs4: –128 ~ +127
78
Element Filter
PAGE PART ELEM KEY
16 E 1
OCTAVE
PAGE PART ELEM KEY
16 E 1
OCTAVE
PAGE PART ELEM KEY
17 E 1
OCTAVE
PAGE PART ELEM KEY
17 E 1
OCTAVE
18-1. FltSclSns
(Filter Scale Sensitivity)
18-2. FltSclVel
(Filter Scale Velocity Sensitivity)
PAGE PART ELEM KEY
18 E 1
OCTAVE
❏
Settings: 0~15
I FltSclSns
Determines the Time Scale (the speed of change in
the FEG over the range of the keyboard) for each
Element. The higher the value, the slower the
change for lower notes and the faster the change for
higher notes.
I FltSclVel
Determines the velocity sensitivity of the FEG Level.
For higher values, the more strongly you play the
keys, the greater the sound change (FEG Level)
becomes.
Filter Scaling Settings
By way of example, you could set the Levels (Offsets)
and Break Points (BP1 to BP4) as follows.
1
BP E1
Ofs –4
Here, the current Cutoff setting is 64. The Offsets
are –4 at BP1 (set to note E1), +10 at BP2 (set to
note B2), +17 at BP3 (set to note G4) and +4 at
BP4 (set to A5). That is, the Cutoff frequencies at
each Break Point are 60, 74, 81 and 68, respectively.
For other notes, the Cutoff frequencies will be on the
straight line connecting the two adjacent Break
Points.
n The Break Point Levels are Offsets used to increase
or decrease the current Cutoff setting at the
specified notes. Regardless of the size of these
Offsets, the minimum and maximum Cutoff limits
(values of 0 and 127, respectively) cannot be
exceeded.
n A note set below the BP1 will become the BP1
Level. A note set above BP4 will become the BP4
Level.
PAGE PART ELEM KEY
18 E 1
OCTAVE
2 3 4
B2 G4 A5
+10 +17 +4