Yamaha S03 Owner's Manual page 73

Element Oscillator/Mixer
(PAGES 1 to 6)
Element Pitch (PAGES 7 to 12)
Element Filter (PAGES 13 to 22)
Element Amplitude (PAGES 23 to 31)
Element LFO (PAGES 32 to 35)
The following is an explanation of the Element
parameters used to edit each Voice.
n The Element settings whose Element Switch is set to
"off" can not be changed and "***" appears in the
display.
1. Element Sw (Element Switch)
This determines whether each Element sounds or not.
PAGE PAGE PART PART ELEM ELEM KEY KEY
1
OCTAVE OCTAVE
❏
Settings: off, on
2. Wave Selection
Select the Wave. Each Element can be assigned a
different wave (sound).
Wave Name
Wave category
PAGE PART
2
OCTAVE
❏
Settings: 1 ~ 453
n Wave numbers indicated with an asterisk (*) and Wave
names indicated with an "at" mark (@) have fixed
parameter values (depending on the sound range). For
these waves, Element editing is limited to the Wave
selection and Element Switch parameters. All other
parameters' values are replaced by a series of asterisks in
the LCD, indicating that they cannot be set.
E 1
ELEM KEY
E 1
Wave Number
3. Level
Set the output level of each Element.
PAGE PART ELEM KEY
3
OCTAVE
❏
Settings: 0 ~ 255
4. Pan
Set the Stereo Pan position for each wave.
PAGE PART ELEM KEY
4
OCTAVE
❏
Settings: Scale, L63 (Left) ~ C (Center) ~ R63 (Right)
Scale: Set the amount by which the sound is panned
left and right according to the position of the note on
the keyboard.
n You can also enter the settings below using the numeric
keypad.
0: Scale
1~63: L63~L01
64: C (Center)
65~127: R01~R63
5-1. NtLmt-L (Note Limit Low)
5-2. NtLmt-H (Note Limit High)
Set the lowest and highest notes of the keyboard range
for each Element. Each Element will only sound for
notes played within its specified range.
PAGE PART ELEM KEY
5 E 1
OCTAVE
❏
Settings: C-2~G8
n You can set the lowest and highest notes in the range by
pressing notes on the keyboard while holding down the
[ENTER] button.
E 1
E 1
PAGE PART ELEM KEY
5 E 1
OCTAVE
73
Element Oscillator/Mixer