Yamaha S03 Owner's Manual page 61

6. Rcv Ch (MIDI Receive Channel)
Set the MIDI Receive Channel for each Part. Each Part
receives MIDI messages according to the channel set
here. Select "off" for Parts that you do not want to
respond to MIDI.
PAGE PART ELEM KEY
6 1
OCTAVE
❏ Settings: 1 ~ 16, off
n For information on setting the MIDI Receive channel in
the Voice mode, see page 94.
7-1. NoteShift
7-2. Detune
These parameters determine the pitch of each Part.
PAGE PART ELEM KEY
7 1
OCTAVE
I NoteShift
Set the amount (in semitones) by which the note
pitch is shifted.
❏ Settings: –24~0~+24
I Detune
Determines the fine tuning setting of the pitch. Use
this to create warm detuning effects by setting each
Part to a slightly different value.
❏ Settings: –12.8 (Hz)~0~+12.7 (Hz)
n Ignore the decimal place when inputting values from the
numeric keypad. For example, to enter the value "–1.5,"
press the following buttons in order: "–," "1," then "5."
8. Mono/Poly
Select monophonic or polyphonic playback. Select
whether each Part is played back monophonically
(single notes only) or polyphonically (multiple
simultaneous notes).
PAGE PART ELEM KEY
8 1
OCTAVE
❏ Settings: mono, poly
n When the Part Mode is set to "drum," "***" appears in
the display and the parameter cannot be set.
PAGE PART ELEM KEY
7 1
OCTAVE
9. Part Mode
This determines whether the Part uses Normal Voices
or Drum Voices.
PAGE PART ELEM KEY
9 1
OCTAVE
❏ Settings:
norm (Normal Voice)
With this setting, Normal Voices can be assigned to
the Part.
drum (Drum Voice)
With this setting, Drum Voices can be assigned to
the Part.
drumS1/2 (Drum Setup 1/2)
Used to play commercially available song data
(switches automatically).
n The part set to a setting other than "norm" is called a
Drum Part.
n If you've edited a drum kit in Drum Voice Edit mode and
you wish to use that kit, set this to "drum."
n When an XG System On message is received from an
external sequencer, this is automatically set to "drumS1."
In order to use the settigs made in Drum Voice Edit,
record the appropriate message in the song data (Part
Mode set to Drum). Refer to the MIDI Data Format
section in the separate Data List.
F0 43 10 4C 08 nn 07 01 F7 (nn=Part number)
(hexadecimal)
61
Part General